DE BEER MM 544 PURPLE RED SERIE 500 1LT
  • DE BEER MM 544 PURPLE RED SERIE 500 1LT

DE BEER MM 544 PURPLE RED SERIE 500 1LT

MM544

De Beer MM 544 Purple Red from the 500 Series. Mixes 1:1 with Uni Thinner (1-141, 1-151, 1-161, 1-181) for professional results.

The colors of the De Beer 500 Series (BeroBase) require the use of base additives MM 577 or MM 588 in metallic and pearl shades for a uniform finish. In some colors, MM 5091 is also used to control the flop effect and ensure maximum color accuracy.


ONLY FOR PROFESSIONAL USE

€42.80
Out-of-Stock

At DS COLOR quality meets simplicity to offer you superior performance. The De Beer MM 544 Purple Red basecoat is a core part of the BeroBase 500 Series system, a paint solution developed for passenger cars, commercial vehicles, and coaches. This system is distinguished by its exceptional optical effect and high durability, ensuring professional and consistent results.

BeroBase 500 Series: the new standard for vehicle refinishing

The BeroBase 500 Series is a paint system that simplifies your work without sacrificing quality. Its 1:1 mixing ratio with thinner makes preparation and application straightforward, eliminating complex calculations. With access to one of De Beer's most advanced color technologies, this system ensures precise matching and is compatible with most OEM finishes. Furthermore, being a streamlined series with fewer colors, it is a cost-effective investment that requires less stock and reduces waste.

Technical characteristics of MM 544 Purple Red

Base Additives

For optimal finishes, especially in metallic and pearlescent shades, the 500 Series colors are always used in combination with the following additives:

· De Beer MM 577
· De Beer MM 588
· De Beer MM 5091 (Flop control additive to adjust metallic orientation and ensure maximum color accuracy)

Components

This color base is used with the following Uni Thinners:

· 1-141 Uni Thinner Fast
· 1-151 Uni Thinner Medium
· 1-161 Uni Thinner Slow
· 1-181 Uni Thinner Ultra Slow

Physical data

Its chemical base consists of special physical drying resins. The RTS viscosity is 15-17 Dincup 4/20°C, with a specific weight of 0.926 kg/l and a % Vol. of solids of 12.

Preparation and application for a perfect finish

For an optimal result, the surface must be properly prepared. It should be cleaned with 1-951 Silicone Remover and sanded with P400 grit or finer. The product is applied in 2-3 coats of 15-25 µm. For effect colors, an additional spray coat is recommended at a lower air pressure (1.2-1.5 bar). Air drying time at 20°C (68°F) is 10-15 minutes to be dust-free and 15-20 minutes to be dry to handle.

MM 544 BEROBASE 500

1 L

UFI:

Warning:Danger Flammable liquid and vapour. Causes skin irritation. Causes serious eye damage. May cause drowsiness or dizziness. May cause damage to organs through prolonged or repeated exposure. Wear protective gloves. Wear eye or face protection. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Do not breathe vapours. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do. Continue rinsing. Store in a well-ventilated place. Keep container tightly closed. Dispose of contents and container in accordance with local, regional, national and international regulations. Contains n-butyl methacrylate, methyl methacrylate and formaldehyde. May cause an allergic reaction.

MM544